Xiaomi Scooter Error Code, Repair Manual

Xiaomi Scooter Service and Repair Manuals, Pinout, Installation, wiring diagram, Setting up the battery, Troubleshooting, Warranty and technical support, Error Codes List

Xiaomi M365 Repair Manual, Wiring Diagram Download
Xiaomi M365 Instruction Manual Download

M365 error codes

Errors can be counted in three places

1) Application, if you manage to connect to the BLE module, which is most often not possible, sometimes there is also a decryption of the error

2) Squeaking in the form of long and short signals

3) Green LED on the main controller of the scooter

all errors are two-digit, long signals are the first digit, short signals are the second digit, by number.

 

Most of the codes are obtained from analysis of the firmware code and through experimentation; inaccuracies are possible. The codes are given for firmware v1.3.0, changes are possible in other versions.

Code Description
10 Communication error with head module  
11

Violation of motor phase A, B and C, respectively.

Current sensor calibration error or problem with power switches.

12
13
28
29
14 Errors in the accelerator handle and brake handle
15
18 Hall sensor error
21 Communication error with BMS
22 BMS Serial Number Error
23
24 Incorrect supply voltage
27 Incorrect serial number. In practice, this means that the controller has not been activated and a service procedure is required, available at the factory, service centers and some dealers.
39 Similar to the previous one, but if the controller was not activated correctly
35 Invalid controller serial number.
36 Battery temperature sensor error or overheating
40 Controller temperature sensor error or overheating

Errors 35 and 36 in practice mean that the battery or controller has not been activated and requires a service procedure available at the factory, service centers and some dealers. Well, or “just” replace the battery or controller.

Ebike Error Codes

Code Description Possible reason
04096 Engine control cannot be communicated Control cable or SN is invalid
08192 Engine control cannot be communicated Battery
16384 Dashboard Error Control board
00256 The device overheated while charging battery or charger or ambient temperature
00512 The temperature of the device is too low for charging battery or charger or ambient temperature
01024 The device overheated while discharging battery or charger or ambient temperature
02048 Device temperature too low to discharge battery or charger or ambient temperature
00016 No voltage Control board or motor
00032 Rotor locked Control board or motor
00064 Sensor malfunction Control board or motor
00128 Break lever malfunction Break lever
00001 Power conductor fault Control board or motor
00002 Current is too high Control board or motor
00004 Overheated Control board or motor
00008 Hall sensor malfunction Control board or motor
Comments: 0